How to Remove Stars from an Astrophoto
When a starless picture helps, how to make one from a stacked nebula or galaxy, and how to put the stars back smaller so the target stands out.
A rich star field can bury a nebula. Stretch hard enough to show the faint gas and every star grows with it, until the picture is more stars than target. Taking the stars out, working on the nebula alone, and then adding the stars back gives you control over both.
When it helps
- Emission nebulae in the Milky Way. The Heart, the Veil, the North America Nebula: thousands of stars sit on top of faint gas.
- Narrowband pictures. Stars in Hα, OIII and SII frames often come out with coloured rings; a starless version lets you colour the gas and keep the stars neutral.
- Dark nebulae. The dust shows as an absence of stars, so a lighter star field makes it read better.
It helps less on a galaxy in a sparse field or on a star cluster, where the stars are the subject.
Start from a good stack
Star removal works on a finished picture, so everything before it matters: calibration frames, enough integration time, and a clean background. A picture with a strong gradient or green cast gives a starless version with the same problems. In Akastroid the stacking, gradient removal and colour calibration run first, on your computer.
Remove the stars in Akastroid
- Open the folder of your deep sky session and stack it.
- In Edit, open the Star removal section in the panel beside the picture.
- Press Remove stars. It uses 3 Image Boost credits; the picture is sent online for this one step only.
- Look at the result. The size, colour and position of everything else are checked against your picture before it is shown.
- Save the starless picture, then press Undo and save the version with stars too.
Star removal is for deep sky only; it is not offered on planets, the Moon, the Sun or nightscapes. More detail, including what it costs, is on the star removal page.
Put the stars back, smaller
With both versions saved, you can recombine them in any editor that has layers:
- Put the starless picture at the bottom and stretch or colour the nebula as you like.
- Put the picture with stars above it, in Screen or Lighten mode.
- Lower that layer’s opacity until the stars sit behind the nebula instead of over it.
Some prefer the starless picture on its own. Both are fine; it is your picture.
Common problems
- Dark holes where bright stars were. With any star remover, the background under a large bright star has to be filled in. Check the brightest stars at full size before you share.
- Small stars left behind. Faint stars in a noisy background can survive. Noise reduction before removal helps.
- Halos and colour rings. These usually come from the optics or the filter, not the removal. A starless picture shows them more clearly because there is less around them.
Other tools
StarNet and StarXTerminator also remove stars; they run inside PixInsight, Siril or Photoshop. If you stack and finish in Akastroid, doing it there saves exporting to another program. The reasons behind starless processing are in star reduction and starless images.
Try it on your own data
Akastroid runs its processing on your own frames and logs each step it took.
Download Akastroid